If you offer to replace the need to share your Hoover SteamVac units, the ICT branch of the shop vacuum cleaner spare parts, complete with the following models: F7205-900, F7220-900, F7210-900, F7221-900, F7225-900, -900 F7226, F7426-900, F7425-900, F7441-980, F7440 and F7430-980-900.
An example is available as a reference. There are about 72 items for sale that are classified in the top and the bottom section. In the upperSection, the upper handle assembly is not readily available, but can be ordered. The amount of the 2-switch technology is offered at $ 4.39. Switch sticks, for a number of 2, is offered at less than $ 4 switch drain is sold at a higher price of U.S. $ 9 Tool The cover is only for models F7220 and F7425-900-900 & & up models available. The control lever and cable management are both sold under $ 4, while the rear handle is sold at more than USD 7.79. The coating turbine for saleU.S. $ 68.69, while the tool caddy is offered at $ 17.89.
The objects that are below $ 10 for the parts in lower price ranges from mounting screw cap and screw cap assembly. There is a slight difference in price between the two, the latter is more expensive. Pictures of both are available for comparison. The handle of the solution tank and dirty water tank handle are sold at less than $ 8 Bolt tank left and right holding, hood, engine O-rings, flexible cableHook, pin holder on the left and right, the right valve cover, the operational arm of the turbine, display button, float, float, and the owners are all together in less than $ 4
Even if you choose to purchase the mounting solution tank, solution tank handle will not be included. For the cover of the tank recovery, but the swimmers brackets included with the purchase. These are also expensive to buy the pieces as they are sold between $ 20 to $ 50.
Nozzles for models startingF7226-F7205 with the 900-900 to sell at $ 79.99, while the costs of F7425 and F7441-900-980 USD to 90.50. Assembly of turbines for F7205-F7226 to 900 to 900 models sold no less than USD $ 54, while the assembly of the turbines from the F7425-900, are less than $ 35 below the cap assembly for all models sold at a constant price of $ 43.49.
The main part and the main part of the front panel of the F200 series are sold at $ 32.59. The same price applies to F7400-900-series. Only the most importantBody panels for models that are included in the standard F400 is available at a cheaper price from $ 10.
All solutions valves for pressure and gravity are the same price of $ 18.99.
Other elements that are not shown in the figure of cord, pipe coating, coating and bare floor tool for all models.
0 comments:
Post a Comment